CZ P-10 Optic Plate Adapter Co Witness Kit 2
Availability: Out of stock
KIT 2 WILL FIT:
- SHIELD RMS
- SHIELD SMS
- J POINT
KIT INCLUDES 2 OPTIC PLATE ADAPTER SCREWS
ALSO INCLUDES CO WITNESS SIGHT SET WITH WHITE DOTS
GUNSMITH INSTALLATION IS RECOMMENDED
Verify that your pistol is unloaded before attempting any of the following steps.
Plate to Slide:
- Remove the two screws from the cover plate on the slide using a T10 driver and remove the cover plate.
- Place the adapter plate onto the slide and secure using the two supplied M3x8 screws, torquing to 12-15 INCH lb. Medium strength threadlocker is recommended.
Sight to Plate:
- Place the optic onto the plate and follow the manufacturer’s mounting specifications.
* With optic installed, screw protrusion beneath the plate should not exceed 2.3mm (.090”) or damage will occur.
- Remove front sight set screw using a 1.5mm hex key, drive the sight out towards the muzzle.
- Remove rear sight set screw using a 2mm hex key, drive sight right to left.
- Install in reverse of operations 1 and 2.
|Accessory Rail||Not Applicable|
|Warranty||Warranty provided by product manufacturer.|