SIG SAFETY LEVER, SRT, P SERIES, SUPER FINISH

SIG SAFETY LEVER, SRT, P SERIES, SUPER FINISH

Sig MPX Upper Assembly, Dust Cover, Ejector, Barrel Clamp, Hardware

Sig MPX Upper Assembly, Dust Cover, Ejector, Barrel Clamp, Hardware

OCG P365 Manual Safety Grip Jig

Rating:
96% of 100
$8.99
OCG P365 Manual Safety Grip Jig
Availability: In stock
SKU
OCG-365-MS-JIG

Designed and 3D Printed in house by Osage County Guns. This cutting jig will aid in converting your non-manual safety P365 or P365XL grip for use with the manual safety conversion kit.

This *CAN* be used for cutting the safety notch in a P365X-Macro grip, however the X-Macro grip itself is too wide to fit the standard safety selector without trimming both sides of the grip. This will likely not be an easy task for a novice or someone without proper tools. We have had customers perform this additional modification successfully but it is much more complicated than the standard safety notch cut.

Please note that this jig is made from soft PLA plastic so if you get overly aggressive you can cut into the jig just as easily as the grip itself - it is not indestructible. We recommend taking your time and going slowly. Cut a little bit at a time as it is always possible to take another cut while you can not put a cut back. Best results seem to come from customers using small hand files, but a rotary dremel-style tool is an option as well with a careful hand.

Includes: One Manual Safety Grip Cutting Jig
Color: May Vary Based on Available PLA Plastics

  • Check Firearm is Unloaded
  • Field Strip Firearm
  • Drift Rear Pin from Shooter's Left to Right
  • Lift Rear of Fire Control Unit (FCU) Up and Slide FCU Rearward to Remove
  • Insert Front of Jig Under the Notches Just Past the Trigger Hole in the Grip
  • Lower Jig Down Into Frame (this may be a tight fit, some force or light sanding/filing may be necessary to the jig itself)
  • Insert Factory FCU Retainer Pin through Grip Module and Cutting Jig
  • Use Jig as a Guide to Slowly Cut Away the Grip Module Until it Matches the Profile of the Trough in the Jig
  • Reverse Process for Re-Assembly
More Information
ManufacturerOsage County Guns
Caliber9mm
Accessory RailNot Applicable
WarrantyWarranty provided by product manufacturer.
Write Your Own Review
You're reviewing:OCG P365 Manual Safety Grip Jig
Your Rating
Customer Questions
No Questions
Did you find what you were looking for?